Frozen pipes may be somewhat common in the wintertime. If your pipes do freeze, you want to check and see if the pipes are busted or cracked. If your pipes are frozen, you can use a hair dryer to try and thaw out the pipes. However, if this will not work, you will need to call in a bathtub who may either try and thaw the lines out another way or they may just end up replacing the section of the line that is broken.
There are two, one on each side of the toilet, closet bolts which hold the toilet to the floor. If there are caps over the bolts, remove or pop them open. Using a small crescent wrench unscrew the nuts from the bolts. Alternate side to side when unscrewing this will be much more important when reinstalling the water line repair bolts but alternate anyhow.
This so impressed me, that I thought, here is the man who might fix my sink problem, and I told him about my kitchen sink. The look on his face was priceless, as he said, "Ridiculous! Sinks don't leak if they're new." He even showed me what to do. He took out a big heavy-duty screwdriver with a big flat-head blade and showed me. "This is what's probably lose." He put the blade of the screwdriver in a notch the size of a giant screw head that was right in the center of the drain basket where the plug sat in.
A plumber becomes a journeyman once they complete their apprenticeship program and they can apply to be licensed. Most of the plumbers today are in the field of journeyman. To get a license to be a journeyman, you need to pass an exam and pay a licensing fee.
Remove the cap of the faucet using slip-joint pliers. Tape the teeth of the pliers to prevent damage of the surface. Remove the faucet cam washer and water line repair the rotating ball.
To avoid this, make sure your toilets screws are always tight and repair any leaks right away. A new wax ring should also be installed any time the toilet is removed such as if you happen to be replacing an old toilet with a newer model that you liked such as a more modern KOHLER brand. Replacing your toilets wax ring is pretty simple to do and can pretty much be done in less than an hour by the average person.
Then, you can take your new shower parts home and reinstall them in the inner assembly. It is very important that everything be aligned properly and tightened to prevent leaks. Beware of over tightening, however, since this can also cause problems. Once you are sure everything is installed properly, replace the cover plate and turn the water back on to test your repair work. With a little bit of work, your do-it-yourself shower repair project can be a success. It does not take an expert, just a little effort and know how.